Kia Forte Forum banner
1 - 6 of 6 Posts

·
Premium Member
Joined
·
1,533 Posts
Discussion Starter · #1 ·
So after I found out how easy it is to actually take out the center console I decided to install LEDs in my cup holder. I tried to wire them separately from my footwell lights but it ended up being a pain in the balls so I just tapped into the existing footwell lights. Here they are. Best photo I could take with the lighting. Sorry.

 

·
Registered
Joined
·
696 Posts
What LED's did you use? I've always been interested in doing this, just have never gotten around to it.
 

·
Registered
Joined
·
536 Posts
Damn! I'm always the last one....Yep I got my lights from Autozone too...the67beast how did you wires yours up? I used a add a fuse and wired them into my fuse box. Interested in doing the footwells too but was worried about all the wiring. Looks good. As far as the cupholders, did you drill the hole for the LEDS on the bottom or side? Keep up the good work!!!

I was also worried about warranty issues if KIA sees me doing all that stuff.....Not sure if that's something to worry about???
 

·
Registered
Joined
·
1,149 Posts
I was also worried about warranty issues if KIA sees me doing all that stuff.....Not sure if that's something to worry about???
simple- tap into the same places that kia recommends (via KGIS)

(( might take a lil sideways thinking- but its all there i think))
 

·
Premium Member
Joined
·
1,533 Posts
Discussion Starter · #6 ·
I wired mine all independent And directly to the battery and a switch so not to mess with warranty / wiring etc.

I did drill 4 small holes in corner areas of the cup holders and just popped them
Through.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top