Kia Forte Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
This intake was purchased at the end of December of 2017 for my 2015 Kia Forte5 SX. I am trading the car in and didn't want this to go with it as they will give nothing for this being on the car. It is in like new condition. I don't have the original box but will make sure that it is packaged very well before shipping.

$260.00

Guaranteed to increase horsepower
Designed to improve throttle response and engine sound
Low restriction aluminum tube
Easy to install, usually in 90 minutes or less
Lasts up to 100,000 miles before service is required (depending on driving conditions)
Replaces stock air intake system
Washable and reusable lifetime air filter
K&N Million Mile Limited Warranty
The K&N 69-5316TS Air Intake fits some Kia cee d, Kia Cerato Koup, Kia Forte Koup, and Kia Forte5 models.
The K&N 69-5316TS Typhoon air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit specific KIA Forte Koup and Forte 5 models. The restrictive factory air filter and air intake housing are replaced by the K&N Typhoon air intake which is designed to dramatically reduce air flow restriction as it smoothes and straightens air flow. This allows your engine to inhale a larger amount of air than the factory air intake. More air means more usable power and acceleration throughout the engine’s RPM range. In addition to more power, this air intake system improves engine sound with more aggressive and deeper acoustics during acceleration. Included is a black rubber topped K&N high-flow air filter and a heat shield that installs into the original air box space. Air is directed through the intake tube into the engine’s throttle body for a guaranteed power gain. The intake tube has an attractive silver powder-coated finish that's made to last and it accommodates the factory crank case vent hose and blow off valve. The oversized cone shaped air filter can be used for up to 100,000 miles before servicing is needed depending on driving conditions. This air intake is relatively easy to install usually in 90 minutes or less using existing factory mounting points. The tools needed are a screwdriver, ratchet set and several wrenches.
 

Attachments

1 - 2 of 2 Posts
Top