Kia Forte Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
405 Posts
Discussion Starter · #1 · (Edited)
Hello.

This is a little listing of what i found for replacing EOM wheels by others OEM from different automakers...

First, let's say that we need
- Bolt pattern : 5 X 114.3
- Offset : High
- Center bore : 67.1 mm
- Lugs : M12 X 1.5

Those with the * have bigger center bore, so center ring may be needed
So far, i have

There we go !

Ok :
- Acura *Legend (91+) / *RSX / *MDX
- Dodge Caliber / Avenger / *Intrepid / Stealth
- Lot of Mazda with 5 lugs : 3's, Protege / Protege 5 / MP3 (03+), 6's
- Hyundai's 5 lugs (Tiburon ('02+), Elantra ('07+), Sonata)
- Almost all Mitsubishis 5 lugs

Forget:
- GMs
- Dodge Neon / SRT
- Mercedes
- Toyotas
- Hondas
- BMWs
 

·
Registered
Joined
·
405 Posts
Discussion Starter · #4 ·
So... U say i may take wheels from an Honda accord which is 5X114.3, with a Center bore of 56.1 and the wheel will sit perfectly anyway ?

If the hub does'nt enter in the wheel... u'll have the wheel too much through the exterior of the car ? Am i right ?
 

·
Registered
Joined
·
405 Posts
Discussion Starter · #6 ·
Ok... so it's like i was say'in at the beginning.. U have to take Idem or bigger center bore if u don't want to use spacers... That's right... i just wanted to be sure that i understood well what i just read...


Thanks
 
1 - 3 of 3 Posts
Top