Kia Forte Forum banner
1 - 3 of 3 Posts

· Premium Member
Joined
·
928 Posts
First and foremost, if you measure between two points, while the car is running, and get 12-14.4 volts you have located a +12 volt line and a ground.. Test it again with car the off and the keys out of the ignition to know if it's accessory powe.

As I said in my pm, the lighter circuit is one you can use. Remove the panel to the right of the pedals, the lighter assembly had a connector behind it so you can undo stand split it with a splicing connector.
 

· Premium Member
Joined
·
928 Posts
believe it pops.. KGIS may be more helpfull... been a while. As for it not working, did you try swapping the wires? LEDS are "polarized" meaning you have a 50% chance of hooking them up correctly if their positive and negative aren't labeled, or you are unsure what the wires are that you are tapping in to.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top