The only chance you have of not rubbing with that offset would be to stretch a 225/35/19 in my opinion. Those wheels are going to sit 1.5 inches further out from the stock wheels.

 

How is it going to perform with a 225 stretched over a wheel that wide?

 

Are you lowered or planning on lowering?

 

Not really, i wanna keep the stock clearance but wanna go with bigger rims to just visually make it more pleasurable

 

Yikes, it's going to tough fitting wider tires with that +35 ET offset. Ideally you want +45 ET, then you can go with either 235 or 245 tires.

But with +35 ET you'll most likely rub with 235 tires, especially with a 8.5" width. So with that I'm kind of in agreement with 2023BD and 225 tires. Granted you could probably make 235 work, just need to negative camber the rear to death.

 

Yeah that's where im kinda stuck because of the offsets!
What you think of wheel spacer? Is there any alternative way to do something to fit 235 on em?

 

Finally got em installed, i went with 235/35/19(8.5). Was really afraid but sit clean without any rubbing.

 

It was from aliexpress, just make sure to buy some good 3mm tape to install it
Here -

https://a.aliexpress.com/_mOegEtQ

 

Everything ”you” are after is on Aliexpress.

Just curious as to why you using quotation marks everywhere.

 

Just curious as to why you using quotation marks everywhere.

Probably a bot. I banned them just for good measure.

 

I figured as much

 

i just bought the same wheels same tire specs as these same 19s do you have any rubbing at this point are no

 

Nope, barely any rubbing! Once in a while when m fully turning during u turn n shit, thats when it rubs a little but not all the time.